SN1500 1.5 kW Fiber Laser Welding Machine

1.5 kW (Laser Power): That’s a decent power level for many welding jobs, especially for metals like stainless steel or mild steel up to moderate thicknesses. The spec says welding thickness ≈5 mm, meaning that’s roughly how thick a single-pass weld you might reliably do under good conditions. Continuous Mode: The laser runs continuously rather than pulsing. Good for steady welds, though sometimes pulsed lasers provide better control for thin materials or heat sensitive work. QBH Output: That’s the type of fiber connector / interface used. QBH is a common industrial standard for high-power fiber lasers. For example, the QBH cable is designed for high-power continuous wave lasers, with good handling of losses, etc. Note: QBH usually gives a “diverging beam output” as opposed to fully collimated beam (unless additional optics are used) which will affect how the focal optics are set up. amadaweldtech.eu Power Adjustment (5-100%): That gives you flexibility. Very useful if you need lower power for thinner sheets to avoid burn-through or excessive heat input. Feeding Wire Diameter 0.8-1.8 mm: You can use filler wire of that diameter with this machine. That’s a decent range for many welding jobs, especially where you need additional material. Working Environment 15-45 °C: Standard thermal limits. You’ll need to avoid too cold or too hot environments; cooling and ambient temp may affect performance.